国产导航在线,中文日韩电影网站,色在线视频观看

By: montis

montis — Tue, 21 Feb 2023 21:45:44 +0000

In reply to taurusfpv. Reading the firmware takes a while. If I remember correctly it took more than half an hour to write the firmware. Arduino Nano should work, though I have not tried with this particular Arduino Board. I have used Arduino Mini Pro.

By: taurusfpv

taurusfpv — Thu, 16 Feb 2023 22:09:01 +0000

hi.How many minutes does it take with xloader?
Will it work with arduino nano atmega328p?

By: dfebrihardy6

dfebrihardy6 — Mon, 08 Aug 2022 02:27:16 +0000

In reply to Helder Vieira.

there’s a little dot on the corner of the chip, align it with the red cable on the clamp. By the way.. you can’t flash the chip with the SPHOST.BRN file, you have to use the original .BIN file from the working chip.

contact me at dfebrihardy6@yahoo.com if you want the original firmware.

By: Helder Vieira

Helder Vieira — Sun, 17 Jul 2022 00:04:14 +0000

In reply to Agnus. Hi Agnus, can u show all pins to connected with clamp? and send the model of the programmer that you use? Thanks

By: Reza

Reza — Wed, 29 Sep 2021 10:54:45 +0000

In reply to Agnus. Hi Agnus, can u show all pins to connected with clamp? Thanks

By: montis

montis — Sun, 05 Sep 2021 12:00:06 +0000

In reply to Agnus. Hi, well at the time of writing this article I was not aware about the CH341A programmer. Also the idea of using simple Arduino board was fascinating me. Thanks for the info.

By: Agnus

Agnus — Fri, 03 Sep 2021 22:20:32 +0000

Why are you using arduino for programing SPI ? There are cheap programers for SPI on ebay (~10euro). With CH341A its possible to flash this chip without soldering. Look: https://www.ebay.de/itm/393455583490 Connect clamp, download dumps: https://drive.google.com/file/d/1XrrhgzeTashTR1-j3ZTARUlilY9I8pG0/view open with programer software, click write. Its simple.

By: montis

montis — Sun, 01 Aug 2021 12:13:25 +0000

In reply to PatrikE. Try to flash the firmware with Arduino/Flashrom as described in the article.

By: PatrikE

PatrikE — Fri, 30 Jul 2021 16:27:44 +0000

I flashed the Sep 23 2019 file on my camera.
I now have a black screen with just the OSD text.
The camera don’t want to go in update mode if i put the older file on the SD any longer..

By: montis

montis — Mon, 03 May 2021 09:43:16 +0000

In reply to David. You can find the firmware dump file dated Sep 23 2019 that works with the newer sensor board. http://bit.ly/Google-Drive-Caddx-Turtle-Firmware-Flashing