Caddx ANT Nano FPV camera

by montis 30/04/2020 | 4:07 2 Posted in New products, Rumors

Caddx has released the teaser with their new nano sized camera called ANT. This new nano sized camera weights only 2 grams. It is a bit heavier than RunCam Nano 3 camera (1.1 gram), but Caddx ANT has screw holes for easier mounting. Camera also has wide range of the input voltage: from 3.7V up to 4S battery. Caddx ANT has 1.8mm lens with a 165° FOV.

I wish Caddx could make a version without the connectors, just the soldered wires directly to the camera board.

Specifications
Model: Caddx Ant
Image Sensor: 1/3″ CMOS Sensor
Horizontal Resolution: 1200 TVL
TV System: NTSC or PAL
OSD menu: Support
Image format: 16:9 or 4:3
Synchronization: Internal
Electronic Shutter: PAL: 1/50~100,000; NTSC: 1/60~100,000
S/N Ratio: >52dB (AGC OFF)
Video Output: CVBS
Lens: 1.8mm
Min. Illumination: 0.001Lux@F1.2
Auto Gain Control: YES
BLC: YES
WDR: Global WDR
DNR: 3D DNR
Dimensions: 14*14mm(with bracket to 19*19mm)
Wide Power Input: DC 3.7-18V
Work Temperature: -20℃~+60℃
Work Humidity: 20%~80%
Weight: 2g (N.W.)

Packing List
Camera x1
3pin FPV silicone cable x1
Warranty card x1
Expend bracket x1
Screws x 4

Available @

Caddx: https://caddxfpv.com/products/caddx-ant-1200tvl-global-wdr-with-osd-2g-ultra-light-nano-fpv-camera

Source: Facebook

Tags:Caddx, Camera, FPV

montis

Comments

GapSnapper Fpv 8/05/2020 | 8:36

I agree with Montis , its well past time to supply solder pads to solder to instead of pin connectors , I’ve got an old Foxeer that I’m tempted to just rip off the pin connectors and solder manually because they just don’t hold up in flight with those stupid molex or whatever wire cradles. Because yea I wanna loose visual 24 stories up in a crowded urban area or out in a park with kids, dogs picknicks vehicles and grandmas all over the place . SARCASM !

Reply
Marc Frank 8/05/2020 | 9:54

I think they should use M7 whoop camera lenses for that fast feel. And I hope the image processing is similarly good as the ratel.

Reply