<tfoot id="8oo20"></tfoot>

<tfoot id="8oo20"></tfoot>

Happymodel Mobula6 brushless whoop

by montis 13/11/2019 | 10:17 0 Posted in New products

Happymodel has announced the release of the Mobula6. It is the smaller brother of the Mobula7 brushless whoop. As you may quess, Mobula7 is 75mm and Mobula6 is 65mm sized whoop. Both have Happymodel SE0802 motors, just Mobula7 has 16000KV and Mobula6 has 25000KV motors. Mobula6 FPV camera is new RunCam Nano3 with the weight of only 1.3g!

Mobula6 has new Happymodel Crazybee F4 Lite 1S flight controller with 4in1 5A ESC and 25mW VTX on one board.

Mobula6 motors have 1mm shaft and spin 31mm Gemfan 1219 triblade props.

Total weight without battery is only 20.0 grams! One of the lightest BNF brushless whoops on the market.

Mobula6 has PH2.0 battery connector and accepts 1S batteries only.

Mobula6 flight video:

Estimated release date: November 30

Available @: https://www.banggood.com/Only-20g-Happymodel-Mobula6-65mm-Crazybee-F4-Lite-1S-Whoop-FPV-Racing-Drone-BNF-w-Runcam-Nano-3-Cam-p-1596918.html

Specification:
Brand Name: Happymodel
Model: Mobula6

Crazybee F4 LiteFlight Controller Built-in ESC & Receiver & VTX	Frsky SPI RX version) CRAZYBEE F4 Lite Frsky version Firmware target: CrazybeeF4FR (Flysky SPI RX version) CRAZYBEE F4 Lite Flysky version Firmware target: CrazybeeF4FS MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 1S battery input (DC 2.9V-4.35V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in 5.8G VTX Built-in SPI Frsky/Flysky receiver Built-in 5V 1A BEC Built-in voltage detection
Onboard Frsky Receiver Version	SPI BUS receiver Frsky D8 compatible Compatible Non EU transmitter D8 model Channels: 8ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
Onboard Flysky Receiver Version	SPI BUS receiver Protocol: AFHDS and AFHDS-2A Switchable Channels: 8ch(AFHDS) or 14ch(AFHDS-2A) No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m Failsafe support
Onboard 5A BLheli_S 4in1 ESC	MCU upgraded to EFM8BB21 Power supply: 1S LiPo/LiPo HV Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: O_H_5_REV16_7.HEX Default protocol: DSHOT600
SE0802 25000KV Motor	Model: SE0802 25000KV Configu-ration:9N12P Stator Diamter:8mm Stator Length:2mm Shaft Diameter:Φ1mm Motor Dimension(Dia.Len):Φ10.5mm14.9mm Weight(g):1.9g No.of Cells(Lipo):1S only
Gemfan 1219 3-Blade Propeller	Brand Name: Gemfan Center Thickness:5mm Prop Disk Diameter:31mm Center Hole Inner diameter:1.0mm Quantity: 4 CW & 4 CCW Weight:0.28g
Onboard 5.8G 40CH 25mW VTX	Output power: 25mw Frequency: 40CH Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels With Race band Smartaudio ready
Runcam Nano 3 FPV Camera	Brand Name: Runcam Model: Nano 3 Item Name: 1/3 CMOS 800TVL Camera Electronic Shutter Speed: Auto Auto Gain Control (AGC): Auto Min. Illumination: 0.01Lux@1.2F D-WDR: Auto Day/Night: Color Power:DC 3-5.5V Current: 110mA@5V 120mA@3.3V Housing Material: ABS Net Weight: 1.2g Dimensions: L14mmW14mmH9mm
Lipo Battery ( Included)	Continuous Discharge Rate: 30C Size: 57mmx12mmx7mm Weight: 8g Connector: PH2.0 Quantity: 4 PCS