久久精品日韩精品,久久久久这里只有精品,国产一级在线观看

By: montis

montis — Tue, 16 Aug 2022 10:24:04 +0000

In reply to mario.

I don’t have this board on hand, but some searching on the inet says, that WiFi has some extremely low range, maybe only a few centimeters from the board. Try put your phone as close to the board as possible and then search for the “ExpressLRS RX” WiFi access point.
The Betaflight serial passthrough might be the other option. Keep the “RC boot” button pressed while powering the board to put the receiver ESP chip into the bootloader mode. Also you might have to hold down *both* buttons on the FC when you plug in USB as per some user advice.

By: mario

mario — Mon, 15 Aug 2022 15:16:53 +0000

In reply to montis. It seems like the elrs cannot be flashed through WiFi although they have the esp chip onboard.

By: Dieter

Dieter — Fri, 22 Jul 2022 12:06:17 +0000

I would like to update Express LRS.
How do I get into the wifi.

By: montis

montis — Thu, 28 Apr 2022 05:41:13 +0000

In reply to Alvaro. First make sure you have the same FW version on the receiver and transmitter module. Then make sure you have flashed the firmware with the same passphrase. This should be enough for the receiver to bind automagically.

By: Alvaro

Alvaro — Thu, 28 Apr 2022 00:54:58 +0000

I’ve been trying to bind this to my happymodel elrs module and can’t get it to work. Idk what else to try, any help?

By: montis

montis — Fri, 31 Dec 2021 15:19:14 +0000

In reply to Chewie. Thanks for the feedback!

By: Chewie

Chewie — Fri, 31 Dec 2021 14:02:34 +0000

I got this flight controller last week and built it up right away as a 65mm tinywhoop. Been flying it a ton and it’s been great. It’s my first flight controller for JHEMCU and I’m very pleased with the quality. I love that they put the ELRS receiver on a uart and not spi so we can update it independently from betaflight.