亚洲欧美日韩中文视频,亚洲三区视频,日韩二区三区

By: richard flores

richard flores — Sat, 11 Dec 2021 19:53:06 +0000

anyone know about the touch panel, can i use the radiomaster touch panel, cuz i don’t see any selling the touch panel for t18

By: montis

montis — Tue, 13 Oct 2020 16:07:18 +0000

In reply to Ray Henderson. Have you checked the unsoldered SD card detection pin? This is known issue and an easy fix. See the photos in the article.

By: Ray Henderson

Ray Henderson — Mon, 12 Oct 2020 20:26:48 +0000

Hi, I have the Jumper T18 Pro. If I hold the trims together and power on I get a screen saying “Write Firmware or Connect to USB” if I connect to USB I get nothing on the PC (no folders appear). If I just power on the Jumper (no trims pushed together) and then connect the USB to PC I get the option to “Use as a Joystick or Connect with USB” I can then see the folders on my PC. If I install the latest Firmware from Open TX I get “NO SD CARD” then flashes up the Open TX screen for a split second and then it shuts down (also tried with the latest SD card contents). When I flash again with Original firmware it powers up ok…any ideas would be greatly welcomed.

By: montis

montis — Mon, 31 Aug 2020 12:30:22 +0000

In reply to fiorenzo agnelli.

do not buy the t18 you can not set the calibration slide and throttle works only at the halfway point

Do you have problems calibrating the sticks in the PC simulator? Have you checked the Radio not working in the simulator issue? Maybe you have the same problem? My friend had very similar problem - the USB driver was wrong (BETTER_USB_DEVICE), then he needed to re-calibrate the sticks in the Windows Joystick settings and then it worked in the Liftoff simulator.

By: fiorenzo agnelli

fiorenzo agnelli — Mon, 31 Aug 2020 12:17:41 +0000

non comprate la t18
non si riesce a settare la calibrazione degli slide e l’acceleratore fu8nziona solo a metà della corsa

By: Fitz

Fitz — Sat, 09 May 2020 10:19:42 +0000

check this out,https://www.youtube.com/watch?v=-CPxdyhhg2Y