欧美色视频免费,一本色道亚洲精品aⅴ,中文字幕一区二区三区乱码在线

By: Flying Wolf

Flying Wolf — Tue, 21 Jan 2020 10:53:33 +0000

Thanks for your time and keep up the good work!

By: Flying Wolf

Flying Wolf — Tue, 21 Jan 2020 10:52:37 +0000

In reply to montis. Thanks for your time and keep up the good work!

By: montis

montis — Mon, 20 Jan 2020 21:14:47 +0000

In reply to Flying Wolf. A good VTX should not blank out on 25mW without the active cooling. I have two Eachine Nano VTX and both dont blank out. They just reduce the power output. Probably a hit and miss with these nano VTX from Eachine. Try contacting the customer support. Have in mind CN has New Year holiday now.

By: Flying Wolf

Flying Wolf — Mon, 20 Jan 2020 20:24:43 +0000

Thank you for this review! I bought and just install one of those in my quad and on the bench, not flying because of the weather it gets really hot and in about 2-3 minutes it blacks out even on 25mw. If i start cooling it blowing some air in it, it gets back. It doesn t seem to be right. Should i ask for another one? Thank you!

By: stephen

stephen — Tue, 12 Nov 2019 22:43:09 +0000

Setup camera control using my last hardware UART so tried to set this with Tramp on SOFTSERIAL (LED_STRIP). Only pit mode works.

By: Ghostface

Ghostface — Sat, 02 Nov 2019 11:17:56 +0000

In reply to Miha. Same problem with tramp not working on uart tx 3 or 6 on an hglrc zeus f4. Had a hglrc tx20 on it before also using tramp which worked fine tho.

By: montis

montis — Sun, 13 Oct 2019 20:04:19 +0000

In reply to Miha.

Hi, Miha. Thank you for your comment. I really appreciate it. I have also read a few users complaining about the SmartAudio (IRC trump) control not working. This is strange issue and I don’t know yet if it is the problem of the Nano VTX. I assume that you have selected the “IRC Trump” as control protocol instead of the Smartaudio in the Betaflight configurator. If yes then could you write your BF version and the FC name?
Oh, and thanks for the correction – You are right, SmartAudio/IRC Trump control line should be connected to the TX pad on flight controller (Read my SmartAudio guide here: http://www.dzskam.com/guide/guide-smartaudio-vtx-control-and-how-to-set-it-up/).

By: Miha

Miha — Sun, 13 Oct 2019 19:20:57 +0000

Hi,

I’ve read your review and really liked it.
I bought 2 of those, unfortunately smartaudio control just doesn’t work.
I’ve found such complaints from many users.
I somehow managed to set the power, band and channel with the button and it works great.
One thing confused me while reading your review. You wrote:
”To setup the IRC Trump control you need to connect green wire from the Nano VTX to any free flight controller RX pad”
Shouldn’t that be TX pad?

Regards, Miha