国产精品一区二区三区免费观看,亚洲免费视频一区,欧美精品一区二区三区久久久竹菊

By: montis

montis — Thu, 16 Sep 2021 18:06:37 +0000

In reply to JuanFR.

AIRF7 board is still not supported by iNav in 3.0.2. The iNav has “limited” number of the targets and developer is picky on the boards. Ask for the iNav support in the https://github.com/iNavFlight/inav/issues/7227

By: JuanFR

JuanFR — Thu, 16 Sep 2021 16:40:49 +0000

In reply to Vitaliy Vavilov. hello i need INAV in this FC :(

By: montis

montis — Thu, 15 Jul 2021 14:33:29 +0000

In reply to JohannisK. SBUS/F.port should be connected to the F.P pad. This is UART4. I may have mixed things up in the article. Also check if the serial RX inversion is turned off set serialrx_inverted = OFF

By: Vitaliy Vavilov

Vitaliy Vavilov — Wed, 14 Jul 2021 16:57:47 +0000

Hello everybody.
Anyone who owns this flight controller and wants to see a target on iNav, please support this request to create a new target on iNav
https://github.com/iNavFlight/inav/issues/7227

By: JohannisK

JohannisK — Thu, 08 Jul 2021 09:41:27 +0000

Hi, and thank you for the review and the tips in this document! It already helped me when I couldn’t get power for the vtx and camera!
When I executed your commands everything worked, though I didn’t have to do this after I upgraded betaflight.

I’ve soldered everything up with an xm+ receiver, which I connected to the sbus port. I believe this is uart4. Though the led’s on the receiver indicate the binding was succesfull I can’t get any input in Betaflight. You’ve mentioned xm and xm+ receivers can be soldered to uart3. Is is possible the inverted signal from xm+ is causing the problem, and uart4 cannot handle this? I’m not sure if uart 3 is more convenient for diect soldering, or if it’s required to solder xm and xm+ receivers to this uart.

Thank you for the help.