国产精品专区免费,麻豆久久久久久久,免费毛片在线

By: montis

montis — Tue, 09 Mar 2021 11:03:33 +0000

In reply to Pascal FAVREAU. A receiver that needs inverted SBUS input should be connected to the pad marked SBUS (located on the bottom part of the FC).

By: Pascal FAVREAU

Pascal FAVREAU — Thu, 04 Mar 2021 15:31:34 +0000

Bonjour,
j’ai installé un r-xsr sur le full speed, mais j’ai la télémétrie mais pas de signal radio, je précise que je n’ai pas inversé le fil jaune s-bus vous avez une idée pour récupérer l’émission sur ma taranis plus sur bétaflight?
merci à tous

By: montis

montis — Wed, 08 Jan 2020 16:34:30 +0000

In reply to sam. Should be the same as SBUS input (marked D/S/P).

By: sam

sam — Wed, 08 Jan 2020 03:20:56 +0000

Where is the PPM input to the FC?

By: montis

montis — Wed, 11 Dec 2019 16:46:22 +0000

In reply to Reuben. Yes, it should be possible. Use TX1 RX1 pads on the bpttom side of the FC.

By: Reuben

Reuben — Wed, 11 Dec 2019 00:44:30 +0000

Can you connect crossfire

By: montis

montis — Sun, 01 Dec 2019 14:50:11 +0000

In reply to Pilotmini_fpv. Sure it should work. It has the same SBUS output as FrSky XM+ that I've used as receiver.

By: Pilotmini_fpv

Pilotmini_fpv — Sat, 30 Nov 2019 09:10:29 +0000

Is it work with r9mm receiver.?

By: montis

montis — Tue, 15 Oct 2019 19:58:45 +0000

In reply to the13.

Unfortunately no manual is available for this FSD F411 FC.
If you are trying to connect r-xsr receiver with S.Port telemetry, then you should use uninverted pad (the pad marked P) on the R-XSR.
Also you could flash the RX firmware with the F.Port and connect the mentioned uninverted S.Port signal from the receiver to the TX1 pad (this is uninverted input) on the underside of this FC. Select FPort as serial receiver protocol in BF configurator.
This is probably the easiest way.

By: the13

the13 — Tue, 15 Oct 2019 17:14:53 +0000

is there any manual for fsd f411 controller ?
can’t enable telemetry through TX1 or soft serial